Dennis's parts for his 2017cc stroker....

Finally getting al the parts together to build my stroker engine, now saving some money to do the last order and to take the crank, flywheel, pressure plate and Berg pouly to the balancer.....Machinework to the case and heads are finished so far..... the parts list contains following:

· As 41 case, full flow, 8mm studs.
· 78,4 mm CB performance crank
· Lightened flywheel (SCAT chromoly)
· Daikin super street disc.
· Gene Berg equalizer pulley.
· Total seal piston rings.
· 90,5 cilinders (short).
· 8.5:1 comp ratio.
· Teflon buttons.
· CB performance race rods (H beam) 5400 (stock length).
· 043 heads (SCAT) with 35.5/40 mm valves (home ported oval shape).
· Gene Berg dual valve springs.
· SCAT chromoly retainers.
· 44IDF Webers with upgrade kit.
· Gene Berg linkage.
· Webcam W 218 (276’ duration).
· SCAT lube a lobe lifters.
· Double trust cam bearings.
· CSP pushrod tubes.
· Gene Berg chromoly pushrods.
· Gene Berg solid rocker shaft.
· 1:25 rockers or 1:1.1.
· 26 mm high performance pump(GENE BERG).
· Gene Berg oil pump cover with pressure relief.
· 3.5 quart oilsump (GENE BERG).
· CB performance straigt cut timing gears.
· Gene Berg swivel feet screws.
· CB performance merged header (41 mm).
· Stainles steel Mondo muffler.
· Bosch 010 dizzy!!!!
· Bosch bleu coil.

Main goal is to build a reliable engine wich wil be street driven and still capable to do some runs on the dragstrip...